Pri uporabi vodovoda za oskrbo z vodo iz HDPE je treba posvetiti pozornost

1. jazt Priporočljivo je, da sprejmete zaščitne ukrepe za polaganje na prostem na prostem in na mestih, izpostavljenih sončni svetlobi.

2.Zakopani vodovodni cevovodi iz HDPE. Cevi z DN≦110 je mogoče poleti namestiti v obliki kače. Cevi z DN≧110 imajo zadostno odpornost na tla in se lahko upirajo toplotnemu stresu, zato obstajadolžine cevi ni treba rezervirati; pozimi to ni potrebno. Rezervirajte dolžino cevi.

3. Wkokošpri namestitvi cevi iz HDPE, če je delovni prostor premajhen (na primer: vodnjaki cevovodov, stropna konstrukcija itd.), je treba uporabiti metode elektrofuzijske povezave.

4. Wkokošconnecting hot-melt sockets, the heating temperature should not be too high or too long, and the temperature should be controlled at 210±10℃, sicer bo povzročilo preveč stiskanja out of the fittings and reduce the inner diameter of the water; wkokošinserting the pipe fittings or the pipe interface should be clean, otherwise it will cause the socket to escape and leak; at the same time, pay attention to control the angle and direction of the pipe to avoid rework.

5. Wkokošconnecting hot melt butting, the voltage is required to be between 200~220V. If the voltage is too high, the heating plate temperature will be too high, and the voltage will be too low, and the docking machine will not work normally; the interface should be aligned during docking, otherwise it will cause insufficient butt joint area, insufficient weld strength, and improper crimping; wkokošthe heating plate is heated, the pipe interface is not cleaned, or the heating plate has impurities such as oil and sand, which will cause the interface to detach and leak; heating time it must be controlled well. The heating time is short and the pipe heat absorption time is not enough, which will cause the welding edge to be too small, and the heating time will be too long, which will cause the welding edge to be too large and may form a false weld.

Ningbo Fangli Technology Co., Ltd., kot proizvajalec s skoraj 30 -letnimi izkušnjami z opremo za proizvodnjo linij ekstruderjev, imamo veliko izkušenj s proizvodnjo opreme in vam lahko ponudimo strokovna tehnična navodila in predloge za nabavo opreme.

https://www.fangliextru.com/pe-pipe-extrusion-line.html

https://www.fangliextru.com/extrusion-equipment-for-type-a-structural-wall-winding-pipe.html